Okay guys...here is a short demo on how to do a Bargue Drawing...I will relay the info as it was relayed to me...I will break it down into steps.
Materials Needed: 2H pencil (trust me you will need it this light...you will do a LOT of correcting)...kneaded eraser...staedtler plastic eraser...thread...drawing paper...drawing board...ruler.
1.) Find a good drawing...one that is simple and one that you can print out fairly large...like the one I have shown below. Now the drawing needs to be really really clean...like the one below...the goal here is ultimate precision and ultimate perfection. You will spend weeks on this trust me.
2.) Print out the drawing (make sure the print out is of exceptional quality so you can see all the details exactly as they are) ...then tape the print out to your drawing board...make sure to tape it down good so it won't move. Then put your paper right up against it to the right or the left (If you are lefthanded) and tape your paper there as well.
3.) Next is a very important step...take a piece of black thread and place it like a plumb line over the printed out drawing...you should place it vertically not horizontally. Be really particular about this...measure the distance to the thread from the top leftmost part of the paper...and make sure at the bottom leftmost part of the paper the thread is the same distance...this will ensure that it is going STRAIGHT down. Make sure to tape the thread down on both sides as you go because you don't want the plumb line to move at all once you place it there. Next...measure the same way with your drawing paper only this time don't use a thread...actually draw a plumb line very very lightly with pencil down the paper...make sure it is perfectly straight down...just as your thread is. (Look at my drawing so far to see what I mean)
4.)Now you can start the drawing...start by taking another piece of thread to use as your measuring tool (use the ruler for all the thread laying measurements...etc...but use the thread when you are drawing it trains your eye better...using a ruler while you are doing the drawing will hurt you in the end...only use it if you are totally stuck or if you really need to check your measurement). Ok so once you have your piece of thread...lay it horizontally on the paper and find the top most part of the drawing...measure horizontally over and mark the same spot on your drawing paper...do the same for the bottom most point of the drawing and then do that eventually for the whole drawing...
5.) The object is PERFECTION...you do the whole drawing in this way but I will emphasize that it needs to be PERFECT...every angle perfectly right...every line exactly the same...when the shading sets in it has to be the exact value...EXACT...feel free to post in the middle class and I will help critique as best I can to point out the flaws.
Now here is my drawing so far...I will post the finished version as soon as I can!