Results 1 to 13 of 23
November 26th, 2004 #1
[WIP Clay Modeling] Mystikead (Update 2005_05_29)
Here is an update:
Sculpture ready for the exhibition
My sculpture out of the furnace.
Now i have to smooth a little the edge to remove defaults and irregularities.
PHOTOS can been seen from my BLOG:
Last edited by HARNELBE; May 29th, 2005 at 03:45 PM.
Hide this ad by registering as a memberNovember 26th, 2004 #2
November 26th, 2004 #3
November 26th, 2004 #4
November 26th, 2004 #5
November 26th, 2004 #6Registered User
- Join Date
- Aug 2004
- Thanked 0 Times in 0 Posts
Looking good. Care to shed more light on the source of your inspiration?
November 27th, 2004 #7
About the source of inspiration, it's a sketche i have done.
Ones of my sources of inspiration.
Last edited by HARNELBE; December 9th, 2004 at 07:23 PM.
December 2nd, 2004 #8
December 7th, 2004 #9
December 9th, 2004 #10
Smoothing to be continued
i taken some picture to see what it still to do...
One technic i use for the smoothing...
Tool i use, it come from a case of manicurist...
CU next week for updates.
December 9th, 2004 #11
what kind of clay are you using? if it is Oil based clay, then you can use Rubbing Alcohol, Isopropyl, and a Bristle brush and it will clean up a lot of the broken clay.
If it is water based clay, then ignore everything I said.
December 10th, 2004 #12
It's a clay with "grog" (i don't know if it's the correct translation, it's what i get using Babelfish... ) i have heard that i could use vinegar to replace the Isopropyl in my case.
By the way, thanks for the advise.
December 10th, 2004 #13