Join 500,000+ artists on ConceptArt.Org.
Its' free and it takes less than 10 seconds!
Hi, I'm new to this forum. I was wondering if anyone can help me out,
by describing the names of the stand parts in the link below....
I don't know what the names are for the parts used in those photographs, but if you look at the photos in the link below you can see a very easy to make sculpting stand using very common hardware-store parts.
Its just an L-bracket(twisted if the horizontal rod is too long), 2 threaded rods, half-dozen nuts/wing-nuts and a wood board.