Question about quicktime

[Unit18_Nate]

I have this virtual pose file thing with a cd full of quick time movies of the same post from 360 degrees. They put the model on a spinning dias then move the model like an inch or two taking one picture per turn until they got a 360 degree movie. Now this is a pretty cool resource as you can also print from it. The problem is that I can't figure out how to manipulate my print. Sometimes I just want to get a 3/4 of the pose printed onto a full size sheet of paper but I can't crop. I also can't change the color balance or levels or even turn the thing black and white. Is there any way around this in quick time? I tried doing a screen cap but I'm not sure where the jpg was stored. Would it be in the quick time program folder?

[Mike Frank]

Screen caps go straight to your clipboard, so you have to paste them into another program like paint or photoshop. Hit Printscreen, open up your paint program, make a new doc, hit ctrl-V.

[Unit18_Nate]

Screen caps go straight to your clipboard, so you have to paste them into another program like paint or photoshop. Hit Printscreen, open up your paint program, make a new doc, hit ctrl-V.


Ok thanks. I was able to paste them into a paint program but not into photoshop.