UH OHwacom cursor is on the wrong monitor

[Dementiak]

Ran into a problem today.... I finally configured my triple display setup. WACOM cintiq 21ux in the middle, dell 2408 on the left and dell 2407 on the right.

finally after a ton of cable pulling, table rearranging and monitor calibrating, i decide to draw.

as i use my pen on the cintiq the cursor moves on the left display (what the hell?). So i tried to calibrate and the calibeation screen appears on the left display again (GADDD!). I've set the cintiq as primary monitor but so far i'm stumped.

You guys have any advice?

[Dementiak]

Oh no not another thread that i start and answer myself....


in the wacom tablet properties... apparently theres a drop down menu that lets you choose which monitor you're calibrating. just choose cintiq... ofcourse DOH :)


Sorry to the administrators for posting a question in haste.
I do hope this might help some people having the same problem.

[Ryn]

Good to hear you found a fix. For future reference, the panel buttons on the side of the cintiqs will also usually have a button set to 'toggle display'. This will swap the cursor between monitors if you need to move between them quickly.

[Dementiak]

cool, thanks ryn :)
just tried it out... pretty cool... i can push my palettes and tools to the other monitors and still control 'em without letting go of the pen!